How to Pair a Yealink Handset with the W70B DECT Base Station

How to Pair a Yealink Handset with the W70B DECT Base Station

How to Pair a Yealink Handset with the W70B DECT Base Station

On this page

Procedure

Before registering a handset, the base station will need to be placed in Registration mode.

Enabling Registration Mode on the W70B Base Station

Long press the register button on the base station until the handset LED flashes.


The base station will now be in Registration mode.

Note: If the base station does pair with the new phone within 90 seconds, the registration mode
will switch off automatically.

Registering a New Handset to a Base Station

  1. Press the Reg soft key to register the handset. The handset will now search for a base station in the registration mode. 

  2. After the handset is registered successfully, the phone prompts Handset Subscribed and Base NO (the last 4 characters of the connected Base’s MAC address).

  3. After the handset is initialized successfully, an icon with the internal handset number and handset name appears on the phone screen.

Note: You can also press OK > Register Handset and then select the desired base to register the
handset. You need to enter the base PIN (default: 0000) after a base is found.

    • Related Articles

    • How Factory Default Yealink W60B

      The following guide describes 2 different methods that you could use to factory reset a Yealink Base. This method can also be applied to the models: Yealink W52B and Yealink W80B. Method 1: From the Base Power off the unit by unplugging the power ...

    • Registering a Handset with the W60B

      How to register a Yealink handset with a single W60B or multiple base stations The following steps may also apply to Yealink models W52B and W80B. With a Single W60B Hold down the Connect button on the base until the top light of the three green ...

    • Yealink Headset UPDATE

      Our Quick Guide to Updating Your Yealink Headset Download and install Yealink USB Connect. Connect Your Yealink Headset to Your Computer via USB. Run Yealink USB Connect. Go to Update Device. Do one of the following: Click Check for Updates, which ...