Factory Reset Yealink W60B Cordless Base Unit

How Factory Default Yealink W60B

The following guide describes 2 different methods that you could use to factory reset a Yealink Base.

This method can also be applied to the models: Yealink W52B and Yealink W80B.

Method 1: From the Base

  1. Power off the unit by unplugging the power cord from the back (for PoE, disconnect the network cable).
  2. Wait for 15 seconds.
  3. With the unit unplugged, press and hold the connect button on the base station.w60b base connect button
  4. While still holding the connect button, plug the power (or network cable if PoE) back into the unit.
  5. Wait until all three lights on the unit are showing as solid green, and release the connect button.
  6. Wait approximately 5 minutes.
  7. Reboot the unit by unplugging it from power for 15 seconds and plugging it back in.

 

Method 2: From a connected Handset

  1. Press the OK button in the middle of the phone to bring up the Phone's menu.ok button
  2. Using the directional buttons, navigate to Settings and press OK.settings
  3. Enter System Settings by pressing 8 on the dial-pad, or scrolling down (with directional buttons) and pressing OK.                                                              system settings
  4. Navigate to Base Reset and press OK.                            base reset
  5. Enter the PIN for your device (default is "0000") and press Done.enter pin
  6. The base will now factory reset and upon completion, will display "Success" (or similar) on the phone screen.                                                                                                              

    • Related Articles

    • Yealink Headset UPDATE

      Our Quick Guide to Updating Your Yealink Headset Download and install Yealink USB Connect. Connect Your Yealink Headset to Your Computer via USB. Run Yealink USB Connect. Go to Update Device. Do one of the following: Click Check for Updates, which ...

    • How to Pair a Yealink Handset with the W70B DECT Base Station

      How to Pair a Yealink Handset with the W70B DECT Base Station On this page Procedure Procedure Before registering a handset, the base station will need to be placed in Registration mode. Enabling Registration Mode on the W70B Base Station Long press ...

    • Registering a Handset with the W60B

      How to register a Yealink handset with a single W60B or multiple base stations The following steps may also apply to Yealink models W52B and W80B. With a Single W60B Hold down the Connect button on the base until the top light of the three green ...